14" Front Tire & Tube

Size: 2.5" x 14"

$31.99

12" Tire & Tube

Size: 2.75" x 12"

$31.99

12"/14" Tire & Tube Set

Front (2.5" x 14") & Rear (2.75" x 12") Tire Set.

$62.99

Super Deep Tread Tire & Tube Set

Maxima Formula K2 2-Cycle Racing Oil - This is a premix only oil, it is for use on bikes with a oil injector block off plug. Available in 16 oz for $10.99 and 1 Liter for $18.99

Maxima Super M High performance Injector 2-Cycle Racing Oil - Super M injector’s smokeless, low ash, anti-scruff formula provides excellent rust and corrosion protection for bikes with oil pumps. $14.99

MTL 75 Maxima Gear Oil - For all air and water-cooled 2-cycle and 4-cycle transmissions with wet clutch systems. Also, designed and tested for wet clutch systems. $8.99

Maxima Assembly Lube 4oz - $9.78

Maxima Engine Cool-Aide 16oz Concentrate - $9.85

Maxima Engine Cool-Aide .5Gal - $9.89
Cool-Aide is not Antifreeze - Do Not use in temps below 32° F

Maxima Chain Guard 14oz

Retails for $11.50

On Sale for $7.49

Maxima Waterproof Grease 16oz - $7.75

High Performance Chain

Size 420, Available in Standard or Heavy Duty Gold $19.99

TDR Super Soft Grips

Night & day difference over standard grip, fits many different bikes and available in Black & Gray. $11.99

Engine Kill Button $18.99

TDR 2-Tone Handlebar Grips (2 Set Sale)

2 sets for $9.99

1/2 Turn Throttle Assembly $19.99

Handlebar Grip Set (for 1/2 Turn Throttle $7.99

Morini SHA 12/14 Carburetor $59.99

Morini PHVA 14mm Carburetor $89.99

Morini PHBG 19mm Carburetor $99.99

Dellorto PHBG Slide Needle $12.99

Dellorto PHBG/SHA Main Jet $5.99

Dellorto PHBG/SHA Pilot Jet $5.99

Fuel Petcock (Bolt-on w/ Twist Knob) $10.99

Fuel Petcock (Lever w/ Thread-On Valve) $24.99

Piston Stop Tool $19.99

Morini Clutch Puller $29.99

Remove or install the Clutch nut or Flywheel nut with this special piston stop. This tool safely keeps the engine from turning over. This allows for the correct torque to be set on these important engine parts.

Please do not use Air Impact Wrench on the Clutch nut or Flywheel. Overtightening can strip the threads or even break the crankshaft. If the Air Wrench is too loose, the nut will fall off while the engine is running causing major engine damage.

Remove or install the Clutch assembly with this special puller. This tool will safely pull these parts off your engine. 

Please do not try to use any other type of tool to remove these parts, because attempting to use force or pry with other tools could break or damage something.

S5 or S6 Gear/Clutch Nut Remover Tool $19.99

Morini S5 Flywheel Puller $24.99

This is a specially made tool that safely allows you to remove the gear in front of clutch assembly on S5 engines.

***note the gear/clutch nut is backward left hand threads.